This cheesecake is one of the desserts I have to make when the strawberry season is coming or when I have strawberries that are about to ripen. Add juicy strawberries and mellow condensed milk on the basis of the soft original light cheese cake. You can taste the small strawberry pulp in every bite. You must not miss the sweet and sour taste. The recipe can be used for a round cake with a diameter of 18 cm / 7 in / 5.4 in.
Step1:Let the cream cheese soften at room temperature. Spread a layer of butter or salad oil on the bottom and all around of the cake mold. Spread baking paper. Cut the baking paper around a little higher than the cake mold 3 to 4cm. Wrap the bottom plate of the cake mold two times with tin paper. Remember to pack it tightly so that the water doesn't seep into the bottom of the cake. When making light cheesecake, it is strongly recommended to choose cake mould with detachable chassis.
Step2:Separate the yolk and egg white. Put the egg white in the refrigerator for later use. Mash the fresh strawberries until they are jam like. Preheat oven to 150 ℃.
Step3:Beat the cream cheese softened in room temperature to a soft paste with an egg beater. Be sure not to leave any particles.
Step4:Add the yolks one by one into the paste. Stir well. Mix the previous yolk before adding the next one.
Step5:Pour in 20 grams of sugar. Stir well.
Step6:Add cornstarch. Stir until well blended. Pay attention to mixing gently at first to prevent the flour from spraying out.
Step7:Add the following ingredients one by one - yogurt, condensed milk, strawberry jam and lemon juice (optional).
Step8:Add one raw material at a time and stir evenly before adding the next one. Mix well.
Step9:Make egg white cream - remove the egg white from the refrigerator. Use the electric beater to quickly beat the egg white until the volume expands to twice.
Step10:Pour in 15 grams of sugar. Continue to beat.
Step11:Pour in the remaining 15 grams of sugar in the process.
Step12:Beat the egg white to Six point seven Distribution. That is, the egg white is no longer liquid, but white flowers, shiny, similar to the state of cream, also known as wet foaming. This step is very important. Don't overdo it. Otherwise, the cake will crack easily during baking.
Step13:In order not to destroy the light protein, the electric egg beater is used as a scraper for stirring. Add a third of the protein first. Homogenize the density of the two mixtures.
Step14:Pour in the remaining protein cream. Slowly. Gently. Stir. When mixing, the strength must not be large. While mixing, slowly rotate the container. Mix from the bottom up.
Step15:Pour the mixed cake paste into the mold. Pat gently on the table. Remove the bubbles from the paste.
Step16:Put the cake mold wrapped with double-layer tin paper into the baking tray. Bak
Step17:
Step18:
Cooking tips:Cream cheese should not be stirred until it returns to room temperature. It can also be wrapped with plastic wrap. Use microwave oven to heat for 1 minute to soften it. Pay attention to the time and temperature not to melt the cheese. Light cheesecake is very sensitive to temperature. In order to ensure the puffy and light taste of the cake and prevent its shrinkage, it is necessary to bake it slowly at low temperature. The function of heating water in the baking tray is to keep the cake moist and reduce the probability of cracking. The temperature of each oven is different. Adjust it flexibly. If it is found that the cake color is too fast or the expansion is excessive during the baking, the oven temperature can be appropriately reduced by about 10 degrees or a layer of tin paper can be lightly covered on the surface. But also pay attention to the height of the tin paper. If it is too low, the cake may swell and stick the tin paper during the baking process. Soak the blade in hot water for a while. Take it out and wipe it with a clean towel / kitchen paper before cutting. The cake cut in this way will be very clean. Every cut